ArmaFlex RS850 adhesive
Specifically formulated adhesive for uniform and safe seam-bonding of flexible ArmaFlex insulation materials
Technical information ArmaFlex RS850 adhesive
Material type
Thixotropic contact adhesive based on polychloropr
Additional material information
- Thixotropic
Special features
- Specially formulated adhesive for uniform and safe seam bonding of flexible ArmaFlex insulation materials.
| Property | Value / Assessment | Standard / Test method | ||||
|---|---|---|---|---|---|---|
| Temperature range | ||||||
| Service temperature |
| |||||
| Weather and UV resistance | ||||||
| Weather resistance | Very good | |||||
| Health and environment | ||||||
| Volatile organic compounds (VOC) content | Fulfills all VOC requirements (French, Italian, Belgian, German AgBB, EMICODE and Eurofins Indoor air Comfort GOLD). | ISO 16000 Parts 3, 6 & 9 | ||||
| Health aspects | MSDS available on request. | |||||
| Green building assessment | Meets the sustainable construction requirements for BREEAM international and DGNB. | |||||
| Other technical features | ||||||
| Application conditions | Application temperature: ideally between + 15 °C and + 20 °C, not below 10 °C. At temperatures below + 5 °C or high relative humidity (above approx. 80%), increased condensation may form on the surfaces of the glued or adhesive films. In these cases, bonding is difficult or impossible. This can be tested using absorbent paper (blotting or crepe paper). | |||||
| Disposal and recycling | Allocation of a waste code number, according to the European Waste Catalogue, should be carried out in agreement with the regional waste disposal company.
Residuals must be removed from packaging and when emptied completely disposed of in accordance with the regulations for waste removal. Incompletely emptied packaging must be disposed of in the form of disposal specified by the regional disposer. More details see relevant Safety Data Sheet. | |||||
| Explosion limits | Lower: 1,1 Vol.%
Upper: 11,5 Vol.% | |||||
| Flash point | approx: - 17 °C | |||||
| Hazard class | Highly flammable liquid and vapour | |||||
| Shelf life | 36 months | |||||
| Solids content | approx. 19.5 % | |||||
| Storage | Material shall be stored in a closed (unopened) container in a dry, cool and well-ventilated place.
Do not store together with: explosive substances; spontaneously combusting substances. Jellification due to frost is reversible. | |||||
| Working time2 | at 20 °C
1. Minimum drying time (airing time): > 2 minutes 2. Contact adhesion time (open time): 10 to 15 minutes 3. Setting time: 24 hours The airing and open time depends on the quantity as well as indoor climate conditions. | |||||
| Yield | Yield of the adhesive applied to both surfaces:
ArmaFlex tubes (thickness > consumption unslotted > consumption slotted): 10 mm > 1120 m/l > 140 m/l 20 mm > 280 m/l > 70 m/l 30 mm > 175 m/l > 45 m/l 40 mm > 130 m/l > 35 m/l ArmaFlex sheets: 3-4 m² /l These figures are a guide only. | |||||
1For temperatures below -40 °C please contact our Customer Service Centre to request for the corresponding technical information. 2The full adhesion of the adhesive is achieved after 168 h. | ||||||